To Install: Only 2 plastic straps between switch cutouts need to be removed & 2 holes drilled., Use a hack saw blade & just straight cut these 2 out, my switches are made to fit perfectly with only cutting out those 2 little straps & drilling 2 holes
The factory left 2 alignment pins in stock dash.
1ST i REMOVED PART FROM DASH
AFTER TAKING OFF BLANK COVER YOU SEE 3 SPOTS FOR SWITCHES
CUT OUT THE BARS
THERE ARE SMALL PLASTIC MOUNTING TABS FOR THE SMALL HOLES,USE THESE TO POSITION PANEL ,DRILL 2 HOLES FOR SHEET METAL SCREWS OR SCREWS AND NUTS
ONCE DASH BEZEL IS IN PLACE, IT GIVES THE ROUNDED CORNER APPEARANCE, AND ONLY THE 2 MOUNTING SCREWS ARE SEEN.
